Call for price
Machine Location:6290 W. State Highway21Bryan, Texas, USA 77807(Opens in a new tab)
Seller Information
View Seller InformationGeneral
Manufacturer
BUSH HOG
Model
1812
Condition
New
Stock Number
10859
Description
The 1812 Flex-Wing Rotary Cutter is designed for small tractors with a PTO horsepower of 50 to 75. The narrow cutting width of 12-feet makes this Flex-Wing ideal for rolling terrain where a wide rigid cutter will not perform as well. Grass, weeds, and brush up to 1 1/2-inch diameter are no match for the hardened parallel uplift blades. The narrow width is also ideal for orchards with prunings that must be cut into smaller pieces. The 1812 has maintenance friendly features, E-Z cleaning decks, high performance cutting and distribution, and it is built Bush Hog® tough for years of reliable service.
PERFORMANCE FEATURES
E-Z clean smooth decks are on the center and wings.
Wing “free float” without movement of wing hydraulic cylinder rod extends cylinder life.
Gearbox oil sight gauge allows the checking of the oil level in a few seconds.
PTO driveline holder is standard.
Wheel spindles are in halves for economy and ease of maintenance.
A single hydraulic hose is standard for lifting. Two hoses are optional for lifting wings independently of center section.
CONSTRUCTION FEATURES
Center section cushions are at each axle arm to absorb shocks near the wheels.
Replaceable full length sideband skids give maximum protection and strength to the sideband.
Wheel hub cap retainers are standard to prevent loss of cap and hub grease.
SAFETY FEATURES
Safety lights for highway travel are standard.
CUTTING WIDTH
12′
CUTTING HEIGHT
2″ – 13″
CUTTING CAPACITY
1 1/2″
TRANSPORT WIDTH*
6′ 8″
TRANSPORT HEIGHT**
5′ 8″
TRANSPORT LENGTH***
13′ 7″
APPROXIMATE WEIGHT (LB.)
3,200
APPROXIMATE TONGUE WEIGHT (LB.)
1,100
MINIMUM TRACTOR PTO HP
50
HITCH
CAST SWIVEL CLEVIS
CENTER DECK
10GA
WING DECKS
10GA
WING CUTTING ANGLES
22° DOWN AND 45° UP
WING LEVEL ADJUSTMENT
TURNBUCKLES
SIDEBANDS
1/4″ X 11 1/2″
TRANSFER GEARBOX (HP)
160
CUTTING GEARBOXES (HP)
65
INPUT DRIVELINE
CATEGORY 4
CUTTING DRIVELINES
CATEGORY 3
BLADE HOLDER
11GA OVAL
BLADES
1/2″ X 3″
BLADE TIP SPEED (FPM)
14,504
AXLE SUSPENSION
RUBBER PADS (CENTER)
CENTER & WING HYDRAULICS
1 HOSE STANDARD
SAFETY TOW CHAIN
STANDARD
Category Specific
Mower Type
Pull-Type
Flex-Wing
Yes
Cutting Height
33.02 cm
Cutting Capacity
30.48 cm
Weights & Dimensions
Cutting Width
203.2 cm